Monitor Throttle or other servo movements with your eLogger V3!...

CHT probe kit for use with OS #8 and 10mm plugs. Requires our Thermocouple Expander Board. Up to two Thermocouple probes can be plugged into the Expander simultaneously....

Loop-around temperature sensor measures temp up to 420 degrees F. Great for looping around motors. NEW: The eLogger V3 supports up to two Hall Effects or Brushless RPM sensors! Up to three temperature sensors can be connected to the eLogger V3 simultaneously (two simultaneously for the V1/V2)....

Now use your eLogger V3 to see Spektrum/ JR Rx holds/failsafes, lost frames, and antenna fades (up to 4 antennas) on your PowerPanel, or logged for later review! Connects between your Spektrum "FlightLog" data port and the eLogger V3's GPS port. Use a servo Y cable to use your FlightLog display s...

Measures your RPM without need for installing magnets. Note: This version is for the eLogger V3 and the V2, which we have been selling since early 2006. The eLogger V2 has the large white letters "V2" (or "U2") on the bottom of the circuit board, near the RPM/Temp pins....

12” (30 cm) 3 pin extension cable for our RPM and Temperature sensors...

2,4 Ghz telemetry display and transmitter for data logger....