The most advanced Remote Identification device

WI-FI and BLE technology

Our Remote ID module is based on the following technologies:

• Wi-Fi (supported NAN and Beacon frames)
• BT (supported BLE, and legacy frames)
• GNSS (GPS, Glonass, BeiDou, QZSS, Galileo)

Using the BLE and WI-FI broadcast technology, our Remote ID (RID) device provides surveillance and drone operator identification capability based on any modern mobile device such as a smartphone or tablet.

Why Remote ID from Aerobits?

• idME PRO (UAS Remote Identification) can be easily connected to Pixhawk controller via JST connector
• Sniffer functionality – receive via Bluetooth and WI-FI signal form other RID devices
• Increase of broadcast power to +20dBm Wi-Fi and +18dBm BLE
• Automatic power adjustment according to the country of use
  supports the newest MAVLink protocol, with Open Drone Id Messages
• Extended configuration options allow choosing a transmission technology
• Its small outline and low power consumption allow to be used in ultra-lightweight drones (20mA)
• AT commands provide feasibility to configure broadcast messages, such as drone identification number, type of aircraft, etc. Additional authentication mechanisms are also available.

Basic technical information