idME, Remote ID module for pixhawk etc.

E-identification for UAS

BLE technology

idME (Remote Identification module) is designed to meet the requirements of remote drone identification and localization in ASTM/ASD-STAN standards.

Using the BLE broadcast technology, our device provides surveillance and drone operator identification capability based on any modern mobile device such as a smartphone or tablet.

Why Remote ID from Aerobits?

•  idME can be easily connected to Pixhawk controller via JST connector. For full operation, a position source (along with other parameters) is required, which is obtained directly from the MAVLink protocol. 
• Small outline and low power consumption allow it to be used in ultra-lightweight drones. AT commands provide feasibility to configure broadcast messages, such as drone identification number, type of aircraft, etc. Additional authentication mechanisms are also available.

Notice:

• FCC certification

• EASA certification
• Compliant with the latest FAA MoC
• In accordance with F3211-19, published in February 2020
• CE certification pending

Features:

• Certification: FCC, EASA
• CE certification pending
• In accordance with F3211-19, published in February 2020
• Capability to work with MAVLINK devices
• BLE broadcast technology compliant with ASTM and ASD-STAN
• Interfaces: UART, USB
• Supports Bluetooth 4.0 and 5.2
• Free Android application available
• Compliant with the latest FAA MoC

Application:

• UAS >250g/open & special category
• U-Space/UTM
• Police/Special forces
• E-identification