E-identification for UAS
BLE technology
idME (Remote Identification module) is designed to meet the requirements of remote drone identification and localization in ASTM/ASD-STAN standards.
Using the BLE broadcast technology, our device provides surveillance and drone operator identification capability based on any modern mobile device such as a smartphone or tablet.
Why Remote ID from Aerobits?
- idME can be easily connected to Pixhawk controller via JST connector. For full operation, a position source (along with other parameters) is required, which is obtained directly from the MAVLink protocol.
- Small outline and low power consumption allow it to be used in ultra-lightweight drones. AT commands provide feasibility to configure broadcast messages, such as drone identification number, type of aircraft, etc. Additional authentication mechanisms are also available.
Notice:
- FCC certification
- EASA certification
- Compliant with the latest FAA MoC
- In accordance with F3211-19, published in February 2020
- CE certification pending
Features:
- Certification: FCC, EASA
- CE certification pending
- In accordance with F3211-19, published in February 2020
- Capability to work with MAVLINK devices
- BLE broadcast technology compliant with ASTM and ASD-STAN
- Interfaces: UART, USB
- Supports Bluetooth 4.0 and 5.2
- Free Android application available
- Compliant with the latest FAA MoC
Application:
- UAS >250g/open & special category
- U-Space/UTM
- Police/Special forces
- E-identification