Walkera G400 Helicopter TX settings for beginner and advanced.
Mix switch
Position 0: Manual mode
Position 1: GPS Hold
Position 2: Return to Launch
- take off always in manual mode
Gear Switch
Position 0: Flying mode
Position 1: Setting mode
Radio settings:
Choose either a new model or check the settings of the original model.
Type – Helikopteri (Heli)
Swash - 1 Servo Normal
STMOD - MODE2
REVERS - all normal
Travel adjust: all 100%
Beginners can set Pitch Travel to 85% H ↑ ja 85% L ↓
For faster responce you can adjust more AIL and ELEV Travel %. * If you set the values too high the servos might bind. Beginners shoud use the factory settings 100% or lower them downto 70%. This way the helicopter is more easy to fly.
THHLD - STATE - ACT
Posit - 0,0%
Throttle hold will keep the throttle at 0%.
Device settings, Devo 7
Gear - GEAR - ACT
AUX2 - MIX - GYRO
Gyro - (Devo 7, Devo 8S, Devo 10, ja Devo 12S)
- Manual
Switch - Mix SW
Pos 0 = 80,0%
Pos 1 = 50,0%
Pos 2 = 0,0%
Throttle Curve
normal flight
L = 0%
M = 50%
H = 100%
Stunt 1
L = 100%
M = 60%
H = 100%
Stunt 2
L = 100%
M = 60%
H = 100%
Pitch Curve
normal flight
L = - 16% *
M = 0% **
H = + 55%
* beginner can use L = 0%. This will give 0 degree negative angle, which is suitable for indoor flying or outdoor flying on a calm day.