FrSky mounting stand for DHT-U/FLD-02...

Connect one or two receivers in redundancy mode. Connect 1-2 LiPo batteries, two for redundacy.  Overload (over 2,6A continous / 8A for 2,5s) protection for each channel. Upto 16 PWM ch (normal servos) from a single S-bus RX. Telemetry feedback for voltage, current, capasity and overload indica...

Dimension: 29×20×2mm Weight: 6.7g Operational Voltage: DC 4 -10 V Current consumption: 25mA@5V Voltage range of the motor wires: 2 to 12S RPM range (for 2 poles brushless motor): 1000rpm to 300000rpm Measurement Range: -20~250 degrees Celsius/ -4~482 degree...

Upgrade S.Port devices Configure S6R/S8R/Sensors with PC software Configure S6R/S8R/Sensors wirelessly with Free Link ...

Shows all connected sensors data and can save the data on SD card. Can change the sensor settings and use to upgrade firmware to receivers etc....

FrSky Sensor Hub connects digital side port (G, TX, RX) of FrSky telemetry receiver and FrSky sensors by the provided cable, to serve as an information collecting and processing center, monitor the model status and feedback all data back to FrSky telemetry module...

Product Functions: 1. Serial port Data-Transmission at S.Port BUS. 2. Analog Signal AD input via S.Port....

Product Functions: 1. Serial port Data-Transmission at S.Port BUS. 2. Analog Signal AD input via S.Port....

This cable set and converter can connect FrSky telemetry from your flight controller(Pixhawk1, 2, 3, 4) to the receiver (R9 Slim+, R9, R9M, X8R, X4R, R-XSR, X6R, S8R, RX8R, X4RSB, XSR). Different cables for different receivers and flight controllers....

Measurement Range: -30~250 degrees Celsius/ -22~482 degrees Fahrenheit Accuracy: 1 degree Celsius/ 1 degree Fahrenheit...

Measures altitude. Measurement Range of Altitude: 0~9000m Accuracy: 0,1m New V2 model works without sensor hub and can be connected directly to the receiver. It also supports FrSky new S.Port technology and other sensors can be daisy chained....

Measures altitude. Measurement Range of Altitude: 0~9000m Accuracy: 1m New V2 model works without sensor hub and can be connected directly to the receiver. It also supports FrSky new S.Port technology and other sensors can be daisy chained....

FrSky Battery Voltage Sensor is provided as Two Way Telemetry System’s Optional Accessory. There are three voltage ranges to choose: 1S lipo for battery voltage range from 0V~6.6V, up to 3S lipo for 0V~13.2V and up to 5S lipo for 0V~19.8V....

FrSky D series accessories : FrUSB-2 upgrade cable for DHT-U...

FrSky Upgrade Cable for DFT/DJT/DHT/8ch Telemetry Receiver/Sensor Hub/FLD-02...