new Airspeed and Altitude MicroSensors have two modes: they work standalone with no additional equipment required, as well revving up your eLogger and PowerPanel LCD for full data logging. These precision instruments use pressure differential to measure Airspeed or Altitude....

new Airspeed and Altitude MicroSensors have two modes: they work standalone with no additional equipment required, as well revving up your eLogger and PowerPanel LCD for full data logging. These precision instruments use pressure differential to measure Airspeed or Altitude....

Lets you power your eLogger from a separate backup battery (4.8v - 6v) if your primary pack dips below about 4.5 v. Note that the eLogger will correctly log the voltage of your primary pack even when the Backup Harness is used....

Monitor Throttle or other servo movements with your eLogger V3!...

CHT probe kit for use with OS #8 and 10mm plugs. Requires our Thermocouple Expander Board. Up to two Thermocouple probes can be plugged into the Expander simultaneously....

eLoggerTM V4 - the Easiest Way to Monitor your Model's Power System! Whether you’re into Electric Model Planes, Helis, Cars, Boats or other models, you need to know how your electric power system performs under actual operating conditions. The eLogger is the product you need to monitor your LiPo, A...

The high G sensor measures up to 40g (at least 38g) in the X and Y axes, and up to 8g in the Z axis....

The low G sensor measures up to 8g (at least 7g) in each of the 3 axes....

Useful if your video equipment uses RCA plugs. Two are needed if both your camera and video transmitter use RCA. Also can be used for audio if your video transmitter's audio in uses RCA....

(NOT compatible with eLogger V3) Increases your eLogger's onboard logging time by 5x! Daisy-chains with all other eLogger MicroSensors!...

Loop-around temperature sensor measures temp up to 420 degrees F. Great for looping around motors. NEW: The eLogger V3 supports up to two Hall Effects or Brushless RPM sensors! Up to three temperature sensors can be connected to the eLogger V3 simultaneously (two simultaneously for the V1/V2)....

(NOT compatible with eLogger V3) Expands your eLogger to support Brushless RPM, Throttle movement recording, and simultaneous recording of two temperatures.Includes integrated Brushless RPM sensor and Y cable for Throttle monitoring. Temperature sensors sold separately....

Now use your eLogger V3 to see Spektrum/ JR Rx holds/failsafes, lost frames, and antenna fades (up to 4 antennas) on your PowerPanel, or logged for later review! Connects between your Spektrum "FlightLog" data port and the eLogger V3's GPS port. Use a servo Y cable to use your FlightLog display s...

Measures your RPM without need for installing magnets. Note: This version is for the eLogger V3 and the V2, which we have been selling since early 2006. The eLogger V2 has the large white letters "V2" (or "U2") on the bottom of the circuit board, near the RPM/Temp pins....

12” (30 cm) 3 pin extension cable for our RPM and Temperature sensors...