|
Balancing charger for LiPo batteries. 800mAh charge current. Input voltage 11-15V. Comes with 12V clips. Suitable power for 220V use: 5 A virtalähde (60W)
JST-XH (DualSky/Align) connectors
- 1. High power, high current, high-performance power conversion circuit.
- 2. Large charging current can shorten charging time greatly.
- 3. Large charging current can shorten charging time greatly.
- 4. Easy to use and operate.
- 5. Plastic case and vents help to cool down the surface of the charger.
B4 Pro SPECIFICATION
- Input voltage: 11.0-18.0V DC
- Charge power: max. 35W
- Charge current range: 0.5-4.0A
- Discharge current range: 0.1-1.0A
- Current drain for balancing LiPo: 300mAh/cell
- LiPo/LiIo/LiFe battery cell count: 1-4 series
- Case: Plastic
- Dimension: 103*65*40mm
- Weight: 160g
1. Correct connection
Color codes:
Standby: Green
Charging: Red
Cell low voltage: Flashing Red
Full: Green
2. Fault description
(1) The +/- port of battery and balance port should be all connected to B4 charger well, If connected incompletely, the B4 charger won't get into charging state.
(2) If the indicator light is red and blinks, please check if the balance port is connected completely, and check if the functions of cell which correspond to this indicator is good. (Please Note: when the indicator blinks red, this state must be reset by cutting off power, so when the indicator blinks red, firstly please check whether the corresponding cell is normal and the balance port is connected well, if both of them have no problem. Then go to cut off power for a while, and turn on power to recharge.
(3) If the +/-ports are connected conversely, B4 charger won't get into charging state either.
|
